ISO 12944, Paints and varnishes

-

ISO 12944, Paints and varnishes — Corrosion protection of steel structures by protective paint systems

  • ISO 12944-1, Part 1: General introduction
  • ISO 12944-2, Part 2: Classification of environments
  • ISO 12944-3, Part 3: Design considerations
  • ISO 12944-4, Part 4: Types of surface and surface preparation
  • ISO 12944-5, Part 5: Protective paint systems
  • ISO 12944-6, Part 6: Laboratory performance test methods
  • ISO 12944-7, Part 7: Execution and supervision of paint work
  • ISO 12944-8, Part 8: Development of specifications for new work and maintenance
  • ISO 12944-9, Part 9: Protective paint systems and laboratory performance test methods for offshore and related structures

Reference

 Corrosion protection of steel structures by protective paint systems



Popular posts from this blog

(Rev.1) ISO Standard for General Tolerance of Dimension Inspection

-
ISO 2768-1, General Tolerances - Part 1: Tolerance for linear and angular dimensions without individual tolerance indications ISO 2768-2, General Tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications ISO 13920, Welding - General tolerance for welded constructions - Dimensions for lengths and angles - Shape and position Rev.1 (Nov.10, 2021) The tolerance class shall be stated on the drawing or the contract document. If the tolerance class is not specified, the following class shall be applied as per the common practice. ISO 2768-1, Tolerance Class: m ISO 2768-2, Tolerance Class: K ISO 13920, Tolerance Class: B & F The QC inspector cannot decide the tolerance class for the acceptance criteria. Prior to the dimension inspection, the QC inspector and the buyer's engineer shall discuss the applicable tolerance class. If the discussion is not possible due to the several reason, the applicable tolerance class shall be stated in the i
Read more

(Rev.1) The dimension tolerance for the piping installation and tie-in point

-
What is the applicable standard and tolerance class for the dimension inspection when the specific tolerance is not stated on the approved drawing? What is the standard tolerance for piping installation and the tie-in point? Regarding steel structures and related materials, if specific tolerances are not addressed in the approved drawing or approved ITP (Inspection and Test Plan), the construction tolerances specified in AWS D1.1 (specifically paragraphs 7.21, 7.22, and 7.23) will be applied. For piping, piping installation, tie-in points, and related materials, if specific tolerances are not addressed in the approved drawing or approved ITP, the construction tolerances specified in ASME B31.3 (specifically Paragraph 335, Erection and Assembly) will be applied. - (Rev.1) Typo & Editorial Errors Corrected
Read more