Services

Heng One Service & Consulting provides inspection and related services in South Korea for the materials, equipment, and packaged items installed in the Oil & Gas, Chemical, Power, Steel Making Plant and General industrial sector.

Services

  • Vendor Inspection, Audit, & Monitoring
  • Pre/Post Shipment Inspection (PSI)
  • WPS / PQR / WPQ verification
  • ITP / Procedures Support
  • Non Destructive Examination (NDE)
  • Positive Material Identification (PMI)
  • Job Expediting
  • Remote Inspection with Google Meet & MS Teams.
  • 3D Scan & Analysis for Tie-in Point
  • QC Document Review

Consulting

  • WPS, PQR, WPQ with ASME XI, API 1104, AWS D1.1
  • Quality Cost Analysis for Bidding
  • Project Coordination
  • Overseas Inspection
  • Development of Quality Management System

Contact Us

If you need one of the above services in South Korea, please click the link below.

Tell me more

Popular posts from this blog

(Rev.0) QC Document Types (EN 10204:2004 vs ISO 10474:2013)

EN 10204 vs ISO 10474 Both standards are almost same. This page does not provide the detail description. But, we can find the good descriptions in Google search about the scope and the definition of each type. Instead of the detail description, you can see the actual sample documents in this page.
Read more

(Rev.1) ISO Standard for General Tolerance of Dimension Inspection

ISO 2768-1, General Tolerances - Part 1: Tolerance for linear and angular dimensions without individual tolerance indications ISO 2768-2, General Tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications ISO 13920, Welding - General tolerance for welded constructions - Dimensions for lengths and angles - Shape and position Rev.1 (Nov.10, 2021) The tolerance class shall be stated on the drawing or the contract document. If the tolerance class is not specified, the following class shall be applied as per the common practice. ISO 2768-1, Tolerance Class: m ISO 2768-2, Tolerance Class: K ISO 13920, Tolerance Class: B & F The QC inspector cannot decide the tolerance class for the acceptance criteria. Prior to the dimension inspection, the QC inspector and the buyer's engineer shall discuss the applicable tolerance class. If the discussion is not possible due to the several reason, the applicable tolerance class shall be stated in the i
Read more

(Rev.1) The dimension tolerance for the piping installation and tie-in point

What is the applicable standard and tolerance class for the dimension inspection when the specific tolerance is not stated on the approved drawing? What is the standard tolerance for piping installation and the tie-in point? Regarding steel structures and related materials, if specific tolerances are not addressed in the approved drawing or approved ITP (Inspection and Test Plan), the construction tolerances specified in AWS D1.1 (specifically paragraphs 7.21, 7.22, and 7.23) will be applied. For piping, piping installation, tie-in points, and related materials, if specific tolerances are not addressed in the approved drawing or approved ITP, the construction tolerances specified in ASME B31.3 (specifically Paragraph 335, Erection and Assembly) will be applied. - (Rev.1) Typo & Editorial Errors Corrected
Read more